Table of Contents
Advertisement
2.
Enter an SNMP v3 user name in the SNMP v3 username: field.
3.
To change the current SNMP v3 password, enter a new password
in the SNMP v3 password: field. The default password
is fluidmesh. To show the password as it is being typed, check
the Show SNMP v3 password: check-box.
4.
Choose the correct authentication protocol from the SNMP v3
authentication proto: drop-down. The available options are
MD5 and SHA.
5.
If needed, choose the correct encryption protocol from the SNMP
v3 encryption: drop-down. The available options are No
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Figure 44. SNMP dialog (v3 selected)
IMPORTANT
The same SNMP v3 user name must be set for all
Fluidmesh units in the wireless network.
IMPORTANT
The same SNMP authentication protocol must be set
for all Fluidmesh units in the wireless network.
Page 108 of 177
Advertisement
Table of Contents
