Table of Contents
Advertisement
70
1-2. Child safety
WARNING
When installing a child restraint sys-
■
tem
Observe the following precautions.
Failure to do so may result in death or
serious injury.
Do not allow children to play with the
●
seat belt. If the seat belt becomes
twisted around a child's neck, it may
lead to choking or other serious inju-
ries that could result in death. If this
occurs and the buckle cannot be
unfastened, scissors should be used to
cut the belt.
●
Ensure that the belt and plate are
securely locked and the seat belt is not
twisted.
●
Shake the child restraint system left
and right, and forward and backward
to ensure that it has been securely
installed.
●
After securing a child restraint system,
never adjust the seat.
When a junior seat (booster seat) is
●
installed, always ensure that the shoul-
der belt is positioned across the center
of the child's shoulder. The belt should
be kept away from the child's neck, but
not so that it could fall off the child's
shoulder.
Follow all installation instructions pro-
●
vided by the child restraint system
manufacturer.
Child restraint system fixed with
an ISOFIX lower anchorage
ISOFIX lower anchorages (ISO-
■
FIX child restraint system)
Lower anchorages are provided for the
outboard rear seats. (Tags or Buttons
displaying the location of the anchor-
ages are attached to the seats.)
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
Installation with ISOFIX lower
■
anchorage (ISOFIX child restraint
system)
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
If the child restraint system on hand is not
within the "universal" category (or the nec-
essary information is not in the table), refer
to the "Vehicle List" provided by the child
restraint system maker for various possible
installation positions, or check the compat-
ibility after asking the retailer of the child
seat. (P.59, 64)
1
Adjust the seatback angle to the
most upright position. When install-
ing a forward-facing child seat, if
there is a gap between the child
seat and the seatback, adjust the
seatback angle until good contact
is achieved.
2
If the head restraint interferes with
your child restraint system, and the
head restraint can be removed,
remove the head restraint. Other-
wise, put the head restraint in the
upper most position. (P.145)
Advertisement
Table of Contents
