Table of Contents
Advertisement
420
7-2. Steps to take in an emergency
To have your vehicle towed
To have your vehicle towed by another
vehicle, the towing eyelet must be
installed to your vehicle. Install the tow-
ing eyelet by following the specified
procedure.
1
Take out the towing eyelet.
(P.437, 447)
2
Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehicle
body as shown in the illustration.
Type A
Type B
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
3
Insert the towing eyelet into the
hole and tighten partially by hand.
4
Tighten down the towing eyelet
securely using a wheel nut wrench
or hard metal bar.
*
: If a wheel nut wrench is not equipped, a
wheel nut wrench can be purchased at
your Lexus dealer.
5
Securely attach cables or chains to
the towing eyelet.
Take care not to damage the vehicle body.
6
Enter the vehicle being towed and
start the engine.
If the engine does not start, turn the engine
switch to IGNITION ON mode.
7
Shift the shift lever to N and release
the parking brake.
When the shift lever cannot be
shifted: P.178, 182
*
Advertisement
Table of Contents
