Table of Contents
Advertisement
442
7-2. Steps to take in an emergency
temperature) after the switch is
turned on.
• Turn the compressor switch off and then
check the tire inflation pressure. Being
careful not to over inflate, check and
repeat the inflation procedure until the
recommended tire inflation pressure is
reached.
• If the tire inflation pressure is still lower
than the recommended level after infla-
tion for 10 minutes (35 minutes at low
temperature) with the switch on, the tire
is too damaged to be repaired. Turn the
compressor switch off and contact your
Lexus dealer.
• If the tire inflation pressure exceeds the
recommended level, let out some air to
adjust the tire inflation pressure.
(P.444)
14
With the compressor switch off, dis-
connect the hose from the valve on
the tire and then pull out the power
plug from the power outlet socket.
Some sealant may leak when the hose is
removed.
15
Install the valve cap onto the valve
of the emergency repaired tire.
16
Attach the air release cap to the
end of the hose.
If the air release cap is not attached, the
sealant may leak and the vehicle may get
dirty.
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
17
Temporarily store the bottle in the
luggage compartment while it is
connected to the compressor.
18
To spread the liquid sealant evenly
within the tire, immediately drive
safety for about 5 km (3 miles)
below 80 km/h (50 mph).
19
After driving, stop your vehicle in a
safe place on a hard, flat surface
and reconnect the compressor.
20Turn the compressor switch on and
wait for several seconds, then turn it
off. Check the tire inflation pres-
sure.
If the tire inflation pressure is below
A
130 kPa (1.3 kgf/cm
The puncture cannot be repaired.
Contact your Lexus dealer.
If the tire inflation pressure is
B
2
or bar, 19 psi):
Advertisement
Table of Contents
