Table of Contents
Advertisement
254
4-5. Using the driving support systems
operated
Large adjustment: Increases or decreases
in 5 km/h (3.1 mph)
increments for as long as the lever is held
In the constant speed control mode
(P.255), the set speed will be increased
or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
mph (1.6 km/h)
operated
Large adjustment: The speed will continue
to change while the lever is held.
*1
: When the set speed is shown in "km/h"
*2
: When the set speed is shown in "MPH"
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
1
Long
2
Medium
3
Short
The vehicle-to-vehicle distance is set auto-
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
*1
*2
or 5 mph (8 km/h)
*1
or 1
*2
each time the lever is
matically to long mode when the engine
switch is turned to IGNITION ON mode.
If a vehicle is running ahead of you, the pre-
ceding vehicle mark
will also be dis-
A
played.
Vehicle-to-vehicle distance set-
tings (vehicle-to-vehicle dis-
tance control mode)
Select a distance from the table below.
Note that the distances shown corre-
spond to a vehicle speed of 80 km/h
(50 mph). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed. When the vehicle is
stopped by system control, the vehicle
stops at a certain vehicle-to-vehicle
distance depending on the situation.
Vehicle-to-vehicle
Distance options
Approximately 50
Long
Approximately 40
Medium
Approximately 30
Short
Resuming follow-up cruising
when the vehicle has been
stopped by system control (vehi-
cle-to-vehicle distance control
mode)
After the vehicle ahead of you starts
off, push the lever up.
Your vehicle will also resume follow-up
distance
m (160 ft.)
m (130 ft.)
m (100 ft.)
Advertisement
Table of Contents
