Table of Contents
Advertisement
282
4-5. Using the driving support systems
The diagram shows the detection range of
the sensors. Note that the sensors cannot
detect obstacles that are extremely close
to the vehicle.
The range of the sensors may change
depending on the shape of the object, etc.
Distance display
■
Sensors that detect an obstacle will illu-
minate continuously or blink. (As the
distance to the object becomes less
than 30 cm (1.0 ft.), the distance seg-
ments may blink.)
Approximate distance
to obstacle
Rear center sensor:
150 cm (4.9 ft.) to 65
*2
cm (1.9 ft.)
Front center sensor:
100 cm (3.3 ft.) to 65
*2
cm (1.9 ft.)
65 cm (1.9 ft.) to 45 cm
*2
(1.5 ft.)
45 cm (1.5 ft.) to 30
*2
cm (1.0 ft.)
30 cm (1.0 ft.) to 15 cm
*3
(0.5 ft.)
Less than 15 cm
*3
(0.5ft.)
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
*1
: The images may differ from that shown
in the illustrations. (P.278)
*2
: Automatic buzzer mute function is
enabled. (P.282)
*3
: The distance segments will blink slowly.
Buzzer operation and distance to
■
an obstacle
A buzzer sounds when the sensors are
operating.
The buzzer sounds faster as the
vehicle approaches an obstacle.
When the vehicle comes within the
approximately 30 cm (1.0 ft.) of the
*1
Display
obstacle, the buzzer sounds contin-
uously.
When 2 or more obstacles are
detected simultaneously, the buzzer
system responds to the nearest
obstacle. If one or both come within
the above distances, the beep will
repeat a long tone, followed by fast
beeps.
Automatic buzzer mute function:
After a buzzer begins sounding, if the dis-
tance between the vehicle and the
detected object does not become shorter,
the buzzer will be muted automatically.
(However, if the distance between the vehi-
cle and object is 30 cm (1.0 ft.) or less, this
function will not operate.)
Advertisement
Table of Contents
