Lexus NX 300 Owner's Manual page 402

Hide thumbs Also See for NX 300:
Table of Contents

Advertisement

specified cold tire inflation pressure level.
The tire pressure warning system will oper-
ate based on this pressure level.
3
Turn the engine switch to IGNI-
TION ON mode.
4
Press
trol switches and select
5
Press
trol switches, select the "Vehicle
Settings" and then press
6
Press
trol switches, select the "TPMS"
and then press and hold the
The "Tire Pressure Recalibrating. Please
Wait Until Complete" will be displayed on
the multi-information display and the tire
pressure warning light will blink slowly 3
times.
When the message disappears, initializa-
tion is complete.
Initializing the tire pressure warning sys-
tem
Initialize the system with the tire inflation
pressure adjusted to the specified level.
The initialization operation
Make sure to carry out initialization after
adjusting the tire inflation pressure.
Also, make sure the tires are cold before
carrying out initialization or tire inflation
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
or
of the meter con-
.
or
of the meter con-
.
or
of the meter con-
.
6-3. Do-it-yourself maintenance
pressure adjustment.
If you have accidentally turned the engine
switch off during initialization, it is not
necessary to restart the initialization
again as initialization will restart automat-
ically when the engine switch has been
turned to IGNITION ON mode for the
next time.
If you accidentally restart the initialization
when initialization is not necessary, adjust
the tire inflation pressure to the specified
level when the tires are cold, and conduct
initialization again.
Warning performance of the tire pres-
sure warning system
The warning of the tire pressure warning
system will change in accordance with the
conditions under which it was initialized. For
this reason, the system may give a warning
even if the tire pressure does not reach a
low enough level, or if the pressure is higher
than the pressure that was adjusted to when
the system was initialized.
When initialization of the tire pressure
warning system has failed
Initialization can be completed in a few min-
utes. However, in the following cases, the
settings have not been recorded and the
system will not operate properly. If repeated
attempts to record tire inflation pressure
settings are unsuccessful, have the vehicle
inspected by your Lexus dealer.
When initializing the tire pressure warn-
ing system, the tire pressure warning light
does not blink 3 times.
After carrying out the initialization proce-
dure, the tire pressure warning light
blinks for 1 minute then stays on after
driving for 20 minutes.
401
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nx 200

Table of Contents