Table of Contents
Advertisement
256
4-5. Using the driving support systems
cle-to-vehicle distance. Select this
mode only when vehicle-to-vehicle dis-
tance control mode does not function
correctly due to a dirty radar, etc.
1
With the cruise control off, press
and hold the "ON/OFF" button for
1.5 seconds or more.
Immediately after the "ON/OFF" button is
pressed, the dynamic radar cruise control
indicator will come on. Afterwards, it
switches to the cruise control indicator.
Switching to constant speed control mode
is only possible when operating the lever
with the cruise control off.
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 30 km/h [20 mph])
and push the lever down to set the
speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the lever
is released becomes the set speed.
Adjusting the speed setting: P.253
Canceling and resuming the speed setting:
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
P.255
■
Dynamic radar cruise control with full-
speed range can be set when
The shift lever is in D.
●
●
The desired set speed can be set when
the vehicle speed is approximately 30
km/h (20 mph) or more. (However, when
the vehicle speed is set while driving at
below approximately 30 km/h [20 mph],
the set speed will be set to approximately
30 km/h [20 mph].)
Accelerating after setting the vehicle
■
speed
The vehicle can accelerate by operating the
accelerator pedal. After accelerating, the
set speed resumes. However, during vehi-
cle-to-vehicle distance control mode, the
vehicle speed may decrease below the set
speed in order to maintain the distance to
the preceding vehicle.
When the vehicle stops while follow-up
■
cruising
Pushing the lever up while the vehicle
●
ahead stops will resume follow-up cruis-
ing if the vehicle ahead starts off within
approximately 3 seconds after the lever
is pushed up.
●
If the vehicle ahead starts off within 3 sec-
onds after your vehicle stops, follow-up
cruising will be resumed.
Automatic cancelation of vehicle-to-
■
vehicle distance control mode
Vehicle-to-vehicle distance control mode is
automatically canceled in the following situ-
ations.
Advertisement
Table of Contents
