Table of Contents
Advertisement
pedal
Selecting constant speed con-
trol mode
When constant speed control mode is
selected, your vehicle will maintain a
set speed without controlling the vehi-
cle-to-vehicle distance. Select this
mode only when vehicle-to-vehicle dis-
tance control mode does not function
correctly due to a dirty radar, etc.
1
With the cruise control off, press
and hold the "ON/OFF" button for
1.5 seconds or more.
Immediately after the "ON/OFF" button is
pressed, the dynamic radar cruise control
indicator will come on. Afterwards, it
switches to the cruise control indicator.
Switching to constant speed control mode
is only possible when operating the lever
with the cruise control off.
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 30 km/h [20 mph])
and push the lever down to set the
speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the lever
is released becomes the set speed.
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
4-5. Using the driving support systems
Adjusting the speed setting: P.262
Canceling and resuming the speed setting:
P.264
Dynamic radar cruise control can be set
■
when
●
The shift lever is in D.
●
Depending on the control mode, this item
can be set at the following speeds.
• Vehicle-to-vehicle distance control
mode: Approximately 30 km/h (20
mph) or more
• Constant speed control mode: Approxi-
mately 30 km/h (20 mph) or more
Accelerating after setting the vehicle
■
speed
The vehicle can accelerate by operating the
accelerator pedal. After accelerating, the
set speed resumes. However, during vehi-
cle-to-vehicle distance control mode, the
vehicle speed may decrease below the set
speed in order to maintain the distance to
the preceding vehicle.
Automatic cancelation of vehicle-to-
■
vehicle distance control mode
Vehicle-to-vehicle distance control mode is
automatically canceled in the following situ-
ations.
Actual vehicle speed falls below approxi-
●
mately 25 km/h (16 mph).
●
VSC is activated.
●
TRC is activated for a period of time.
When the VSC or TRC system is turned
●
off.
●
The sensor cannot detect correctly
because it is covered in some way.
265
4
Advertisement
Table of Contents
