Setting The Display/Operation Mode; Setting Source Names And Destination Names; Setting The Transition Operation Buttons And Display Mode - Sony XVS-G1 User Manual

Setting the Display/
Operation Mode
Setting Source Names and
Destination Names
You set the source name and destination name to use in the
control panel.
Note
The group number of an NS-Bus alias name must be set
beforehand.
For details, see "Selecting an Alias Name Group"
(page 340).
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Source/Dest Name] group, select a name to use
in the control panel.
Sw'er Local: Use the name set on the switcher.
NS-Bus Alias: Use the NS-Bus alias name set in LSM
(Live System Manager).
3
In the [Name Display Mode] group, select a display
mode.
Auto: Display four characters per line, up to four lines.
2 Characters: Display first two characters on one line.
4 Characters: Display first four characters on one
line.
Notes
• Line breaks in names are enabled only when [Auto]
is selected.
• Up to two lines are displayed when the display mode
is set to split display.
Enabling the alias name link function
When the link function is enabled, you can replace a
source name set on the switcher with an NS-Bus alias
name set in LSM.
The source name is updated each time the alias name is
updated. This allows you to always use the same name
between LSM and the switcher.
The NS-Bus alias name is reflected in the source name
setting in the Home > Setup > Xpt Assign menu, hence the
name set in LSM is also displayed when the [Sw'er Local]
button in the [Source/Dest Name] group is set to the on
state.
Notes
• When the [NS-Bus Name Link] button is set to the on
state, the settings of all source names for the switcher
(including wiring traceback), not just in the Home >
Setup > Xpt Assign menu, are always replaced by the
NS-Bus alias name.
• To display the NS-Bus alias name on a multi viewer
subscreen, you must set the [NS-Bus Alias] button in the
[Source/Dest Name] group to the on state and set the
[NS-Bus Name Link] button to the on state.
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
Set the [NS-Bus Name Link] button to the on state.
3
Check the message, then press [OK].
Setting the Transition Operation
Buttons and Display Mode
Setting the transition rate display
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Trans Rate Display] group, select a display
mode.
Frame: Display as number of frames.
Timecode: Display as timecode.
Setting the operation when the [FTB]
button is pressed during fade-to-black
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [FTB] group, select an operation mode.
Continue: Continue the transition.
Cancel: Cancel the transition and return to the
previous state before executing fade-to-black.
Setting the independent key transition,
auto transition execution button display
Note
Enabled using a [KEY1 TRANS] to [KEY8 TRANS]
button in the transition control block.
324