Sony XVS-G1 User Manual page 104

To swap color 1 and color 2 in a color mix
Open the Home > M/E-1 > Bus/Transition > Wipe > Matte
Adjust menu (11109.34) and set the [Color Invert] button
to the on state.
To set modifiers for a dedicated pattern for a
color mix
You can set the following modifiers in the Home > M/E-1
> Bus/Transition > Wipe > Matte Adjust menu (11109.34).
Position:
Set the [Position] button to the on state and set the
parameters.
For details about setting parameters, see "Setting the
wipe pattern position (Position)" (page 108).
Multiplication:
Set the [Multi] button to the on state and set the
parameters.
For details about setting parameters, see "Replicating
a wipe pattern (Multi)" (page 109).
Aspect:
Set the [Aspect] button to the on state and set the
parameters.
For details about setting parameters, see "Setting the
aspect ratio of a wipe pattern (Aspect)" (page 109).
Rotation (angle):
Set the [Angle] button in the [Rotation] group to the on
state and set the parameters.
For details about setting parameters, see "Rotating a
wipe pattern (Rotation)" (page 108).
Rotation (speed):
Set the [Speed] button in the [Rotation] group to the on
state and set the parameters.
For details about setting parameters, see "Rotating a
wipe pattern (Rotation)" (page 108).
Setting the wipe pattern position (Position)
You can move a wipe pattern to a desired position.
Position disabled
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Main Modify menu (11109.35).
2
Set the [Position] button in the [Position] group to the
on state and set the following parameters.
To return the pattern position to the center of the
screen
Press the [Center] button in the [Position] group.
To return a pattern from a moved position to the
center of the screen as a transition progresses
Set the [Auto Center] button in the [Position] group to the
on state.
Rotating a wipe pattern (Rotation)
Angle
Wipes with a pattern at a fixed angle.
Speed
Rotates a pattern at a fixed speed.
Magnitude
Rotates a pattern through the specified angle in a single
transition.
1
Position enabled
2
104
No. Parameter Adjustment
1 Position H Horizontal position
• Negative values move left.
• Positive values move right.
2 Position V Vertical position
• Negative values move down.
• Positive values move up.
Angle disabled
Open the Home > M/E-1 > Bus/Transition > Wipe >
Main Modify menu (11109.35).
In the [Rotation] group, select a rotation type.
When the [Angle] button is selected, set the following
parameter.
Angle enabled