Sony XVS-G1 User Manual page 213

To select and copy all registers, place a check mark in
the Select All checkbox.
You can also press the [Select Register(s)] button and
enter a register number in the numeric keypad
window.
6
Press the [Select] button in the [Region] group on the
right.
The [Select Region] window appears.
7
Set the button for the copy destination region to the on
state.
Select a tab to change the region to display.
8
Press [OK].
9
In the list on the right, select a copy destination
register.
When multiple registers are selected, select the first
copy destination register.
You can also press the [Select Destination] button and
enter a register number in the numeric keypad
window.
The copy destination of the first register selected on
the left is the first register selected on the right, and the
subsequent registers on the right in the same relative
positions as the selected registers on the left become
copy destinations. The first register on the right is
shown in light blue, and the subsequent copy
destination registers are shown in blue gray.
10
Press the [Copy] button.
11
Check the message, then press [OK].
To copy without renaming a destination register
Set the [w/o Name] button to the on state.
Moving a register
Notes
• An empty register cannot be moved.
• A locked register cannot be moved.
Select a move source register and move destination
register in the same way as for copying a register and press
the [Move] button.
For details, see "Copying a register" (page 212).
To move without renaming a destination register
Set the [w/o Name] button to the on state.
Swapping registers
Select the registers to swap in the same way as for copying
a register and press the [Swap] button.
For details, see "Copying a register" (page 212).
To swap without renaming the registers
Set the [w/o Name] button to the on state.
Changing main/sub configuration data in
multi program 2 mode
When an effect timeline is recalled on main or sub in multi
program 2 mode, only the keys being used on main and
sub, according to the operation mode configuration data of
the switcher bank, become the recall target.
You can also automatically change the operation mode
configuration data saved in a register when copy/move/
swap operations are performed between main and sub
registers.
You can enable/disable this using the [MP2 Auto Correct]
button when main and sub on a switcher bank are selected
as the target regions in the Home > Register > Effect
Timeline > Edit Register > Copy/Move/Swap menu
(18301.33).
On: Change the operation mode configuration data for
main and sub.
Off: Do not change the operation mode configuration data.
Note
The setting of the [MP2 Auto Correct] button is common
to snapshots.
Locking a register
1
Open the effect timeline register display menu.
To lock a multi region register
Open the Home > Register > Effect Timeline > Edit
Register > Browse Multi Rgn menu (18301.31).
To lock a single region register
Open the Home > Register > Effect Timeline > Edit
Register > Browse Single Rgn menu (18301.32).
2
Select the target region to set.
For details about selecting multiple regions, see "To
select a region" (page 211).
For details about selecting a single region, see "To
select a region" (page 212).
3
In the list on the left, select the target register to lock.
To select and lock multiple registers, place a check
mark beside the target registers to lock.
213