Saving A Snapshot - Sony XVS-G1 User Manual

6
Press [Enter] in the numeric keypad area.
The specified register is recalled.
To undo a register recall
To undo a recall immediately after recalling a register,
press the [Undo] button.
To set the duration for an effect dissolve
temporary attribute
You can set the duration for an effect dissolve temporary
attribute for each region.
Select the target region to set, press the [Temp Diss
Duration] button, and enter a duration (number of frames)
for the effect dissolve in the numeric keypad area.
Selecting a register
Select a register using the numeric keypad area at the
bottom right of the [Recall/Store Register] window.
Enter a register number in the numeric keypad area and
press [Enter] to apply the setting.
When you enter a register number, the register number and
the following information appears on the numeric keypad
area display.
e: The register is empty for the currently selected region.
E: The register is empty for all selectable regions.
L: The register is locked.
To search for an empty register, press [.] (period).
To search for an empty register common to all selectable
regions, press [.] (period) again.
Note
Searching for an empty register is enabled only when

saving a snapshot.

Region display section
The region display section at the top right of the [Recall/
Store Register] window shows the region selection status.
The selected regions are displayed in white characters. The
reference region is displayed inverted.
Saving a Snapshot
Switcher bank region snapshot
The same memory recall buttons as in the memory recall
section of the Flexi Pad control block are displayed in the
Common > Snapshot menu of the switcher bank. The
settings and display of the memory recall buttons in the
Flexi Pad control block and in the menu are linked.
This section describes the M/E-1 menu as an example.
Set the state to save in a snapshot and use the following
procedure to save in a snapshot register.
1
Open the Home > M/E-1 > Common > Snapshot menu
(11110.21).
2
Press the [Store] button in the [Mode] group.
3
Press the [Bank] button and enter a bank number in the
numeric keypad window.
The memory recall section switches to display the
selected bank.
4
Press the button for the target register to save.
The register button is lit orange and the snapshot is
saved.
Note
If you press a register button in which a snapshot is
already saved, the register data will be overwritten.
5
Set attributes.
Set attributes for a register as required.
To add the auto transition attribute
Set the [Auto Transition] button to the on state.
To add the effect dissolve attribute
Set the [Activate] button in the [Effect Dissolve] group
to the on state.
Press the [Duration] button in the [Effect Dissolve]
group and enter a duration (number of frames) for the
effect dissolve in the numeric keypad window.
To add the cross-point hold attribute
In the [Xpt Hold] group, set the button for the target
bus to the on state.
A: Background A bus
B: Background B bus
Utility 1: Utility 1 bus
Utility 2: Utility 2 bus
DME External: DME external video bus
Key 1 to Key 8: Key 1 bus to key 8 bus
To delete a register
Note
A locked register cannot be deleted.
1
Press the [Delete] button in the [Mode] group.
2
Select a bank and press the button for the target
register to delete.
To rename a register
Note
A locked register cannot be renamed.
1
Press the [Rename] button in the [Mode] group.
219