Transition Type; Setting A Transition Type - Sony XVS-G1 User Manual

Transition Type

You can set the way in which the transition occurs.
The transition type is configured using the transition
control block or the menu.
For details about transition types, see "Transition type"
(page 54).

Setting a Transition Type

Setting a transition type (transition control
block)
You can select a transition type using the transition control
block of the target switcher bank.
Notes
• The buttons used for configuring the transition type must
be assigned to the transition settings section of the
transition control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
• When the operation mode of the switcher bank is set to
multi program mode or multi program 2 mode, preset
color mix cannot be used when selecting a key for a next
transition.
• When the operation mode of the switcher bank is set to
multi program mode or multi program 2 mode, there
may be cases in which two or more transition type
selection buttons are lit.
1
Select a transition type using the transition type
selection buttons.
Press the [MIX] button, [NAM] button, [SUPER MIX]
button, [PST COLOR MIX] button, [WIPE] button,
[DME WIPE] button, or a [FM1&2 CLIP] to
[FM15&16 CLIP] button, turning it on.
2
Set the transition type.
Make the required settings for the selected transition
type.
When a mix, non-additive mix, super mix, preset
color mix, wipe, or DME wipe is selected
Set the transition rate.
For details about the transition rate, see "Transition
Rate" (page 60).
When super mix is selected
Set the output level at the mid-point of the transition.
For details, see "Setting Super Mix" (page 59).
When preset color mix is selected
Set the color matte to insert during the transition.
For details, see "Setting a Preset Color Mix"
(page 59).
When a wipe is selected
Set the wipe pattern.
For details, see "Setting a Wipe" (page 99).
When a DME wipe is selected
Set the DME wipe pattern.
For details, see "Setting a DME Wipe" (page 115).
When a clip transition is selected
Set the clip transition.
For details, see "Setting a Clip Transition"
(page 123).
Setting the key transition type (menu)
This section describes the M/E-1 menu as an example.
1
Open the Home > M/E-1 > Bus/Transition >
Transition > Transition Type menu (11109.21).
2
Select a transition type in the [Transition Type] group.
Mix: Mix
NAM: Non-additive mix
Super Mix: Super mix
Preset Color Mix: Preset color mix
Wipe: Wipe
DME Wipe: DME wipe
FM 1&2 Clip to FM 15&16 Clip: Clip transition
3
Set the transition type.
Make the required settings for the selected transition
type.
When a mix, non-additive mix, super mix, preset
color mix, wipe, or DME wipe is selected
Set the transition rate.
For details about the transition rate, see "Transition
Rate" (page 60).
When super mix is selected
Set the output level at the mid-point of the transition.
For details, see "Setting Super Mix" (page 59).
When preset color mix is selected
Set the color matte to insert during the transition.
For details, see "Setting a Preset Color Mix"
(page 59).
58