Sony XVS-G1 User Manual page 117

Note
Cropping cannot be set for the following patterns.
• Mosaic pattern number 1701
• Defocus pattern number 1702
• Crop Slide pattern numbers 2661, 2662
Target channel for modifiers
For DME wipe patterns in 1-channel mode, the 1st channel
becomes the target.
For DME wipe patterns in 2-channel mode, select the
target channel from the 1st channel and 2nd channel. For
DME wipe patterns in 3-channel mode, select the target
channel from the 1st channel, 2nd channel, and 3rd
channel. You can select multiple channels. Depending on
the DME wipe pattern and modifiers, all channels may be
controlled by the 1st channel.
Note
Channels cannot be selected for the direction setting.
Specifying the DME wipe pattern direction
(Direction)
1
Open the Home > M/E-1 > Bus/Transition > DME
Wipe > Edge/Direction menu (11109.44).
2
In the [Direction] group, select a DME wipe direction.
Normal: DME wipe in normal direction.
Normal/Reverse: Alternate directions between
normal and reverse after each transition.
Reverse: DME wipe in the opposite direction of the
normal direction.
To set the wipe direction using buttons in the
transition control block
You can set the DME wipe direction using the transition
control block of the target switcher bank.
Note
The buttons used for configuring the DME wipe direction
must be assigned to the transition settings section of the
transition control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
Press one of the following wipe direction selection
buttons.
[NORM] button: Normal
[NORM/REV] button: Normal/Reverse
[REV] button: Reverse
Modifying a DME wipe pattern edge (Edge)
1
Open the Home > M/E-1 > Bus/Transition > DME
Wipe > Edge/Direction menu (11109.44).
2
In the [Ch Select] group, select the target channel to
set.
3
In the [Edge] group, select a type of edge.
Border: Adds a border to a pattern.
Soft Border: Softens a border applied to a pattern.
When the [Border] button is selected, set the following
parameters.
No. Parameter
1 Width
3 Luminance
4 Saturation
5 Hue
When the [Soft Border] button is selected, set the
following parameters.
No. Parameter
1 Width
2 Inner Soft
3 Luminance
4 Saturation
5 Hue
Note
When multiple channels are selected, the setting
values for the channel with the lowest number are
displayed. When you adjust the setting values, this
adjusts the settings on the other channels by the same
amount.
Setting the DME wipe pattern position
(Position)
1
Open the Home > M/E-1 > Bus/Transition > DME
Wipe > Modify menu (11109.45).
2
In the [Ch Select] group, select the target DME
channel to set.
3
Set the [Position] button in the [Position] group to the
on state and set the following parameters.
117
Adjustment
Border width
Luminance
Saturation
Hue
Adjustment
Border width
Softness of inner edge of
border
Luminance
Saturation
Hue