Aux Bus Control Block Settings; Setting The Aux Bus Operation Mode; Setting The Router Operation Mode - Sony XVS Series User Manual

The Side Flags Button Assign menu (7322.10)
appears.
2
Press [Side Flags Btn Assign], turning it on.
AUX Bus Control Block
Settings
Setting the AUX Bus Operation
Mode
Assigning a bus to an AUX delegation
button
You can assign a bus to the 1st row/2nd row delegation
buttons of the AUX bus control block (AUX bus operation
mode).
1
Open the Engineering Setup >Panel >Aux Assign
menu (7323).
The left side of the status area shows the delegation
button numbers and the assigned buses, and the right
side shows a list of assignable buses.
2
Select the target button number to set.
3
Selects a bus to assign.
4
Press [Set].
To inhibit operation of buttons
Select the target button number to set, and press [Inhibit].
To set the [SHIFT] button operation
In the <Shift Mode> group, select one of the following.
Hold: The bus on the shifted state of the delegation button
is enabled while pressing the [SHIFT] button.
Lock: Pressing the button toggles between the buses on
the shifted and unshifted state of the delegation
buttons.
Note
The [SHIFT] button operation mode is enabled only when
second delegation mode is set.

Setting the Router Operation Mode

This sets the destination selection buttons, source selection
buttons, and level selection buttons of the AUX bus control
block (router operation mode).
Note
You configure the destination selection buttons, source
selection buttons, and level selection buttons in the Router
>Router Control >Router Control menu (5111).
382