Sony XVS-G1 User Manual page 103

For the edge fill, you can use a color matte or the utility 2
bus signal. For a color matte, you can select a single color
(color 1 only) or a color mix (mix of color 1 and color 2).
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
In the [Edge] group, select a type of edge.
When the [Border] button is selected, set the following
parameter.
No. Parameter
1 Width
When the [Soft] button is selected, set the following
parameter.
No. Parameter
1 Soft
When the [Soft Border] button is selected, set the
following parameters.
No. Parameter
1 Width
2 Inner Soft
3 Outer Soft
To set an edge fill
When a border or soft border is selected, set the edge fill.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
In the [Edge Fill] group, select an edge fill signal.
Utility 2 Bus: Utility 2 bus signal
For details about selecting a signal, see "Chapter 4
Selecting Signals" (page 46).
Matte: Color matte
When the [Matte] button is selected, set color 1 using
the following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
To mix color 1 and color 2 color mattes
When color matte is selected for an edge fill, you can use
a dedicated pattern to mix color 1 and color 2.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Matte Adjust menu (11109.34).
Adjustment
Border width
Adjustment
Edge softness
Adjustment
Border width
Softness of inner edge of
border
Softness of outer edge of
border
Adjustment
Luminance
Saturation
Hue
2
Set the [Mix Color] button in the [Edge Matte] group
to the on state and set the following parameters.
No. Parameter
1 Size
2 Soft
To set a single color, set the [Flat Color] button to the
on state.
Note
The [Flat Color] button parameters are shared with the
[Matte] button parameters in the [Edge Fill] group in
the Home > M/E-1 > Bus/Transition > Wipe > Pattern
Mix/Edge/Direction menu (11109.33).
3
Press the [Mix Pattern Select] button.
A pattern selection window appears.
4
Set the button for the target pattern to the on state.
Note
Dedicated patterns 1 to 24 are the same as standard
wipe patterns 1 to 24.
5
Press [OK].
6
Press the [Color 1] button and set color 1 using the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
Note
The [Color 1] button parameters are shared with the
[Matte] button parameters in the [Edge Fill] group in
the Home > M/E-1 > Bus/Transition > Wipe > Pattern
Mix/Edge/Direction menu (11109.33).
7
Press the [Color 2] button and set color 2 using the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
103
Adjustment
Pattern size
Softness of the pattern contour
Adjustment
Luminance
Saturation
Hue
Adjustment
Luminance
Saturation
Hue