Setting Key Priority - Sony XVS-G1 User Manual

Setting Key Priority

Setting the key priority (transition control
block)
You can set the key priority using the transition control
block of the target switcher bank.
Note
The buttons used for configuring the key priority must be
assigned to the transition settings section of the transition
control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
1
Press and hold the [PRIOR SET] and press the [KEY
PRIOR] button to select the target key priority (current
key priority or key priority for after the transition) to
set.
When the [KEY PRIOR] button is lit green, the key
priority setting for after the transition is selected.
When the [KEY PRIOR] button is not lit, the current
key priority setting is selected.
2
Set the key to display at the front.
Press and hold the [PRIOR SET] button and press a
[KEY1] to [KEY8] button.
The selected key is set to be frontmost (priority 1).
To set the key priority for after the transition to the
same setting as the current setting, press and hold the
[PRIOR SET] button and press the [BKGD] button.
Note
The [BKGD] button is enabled only when in the mode
for changing the key priority for after the transition.
3
Repeat steps 1 and 2 to set the key priority, as
required.
Setting the key priority (menu)
This section describes the M/E-1 menu as an example.
1
Open the Home > M/E-1 > Common > Key Priority/
Key Assign menu (11110.11).
2
Select the target key priority (current key priority or
key priority for after the transition) to set.
When setting the current key priority
Press the [Edit] button for [Current Key Priority]. The
[Current Key Priority] window appears.
When setting the key priority for after the
transition
Press the [Edit] button for [Next Key Priority]. The
[Next Key Priority] window appears.
3
Set the buttons for the keys to set to priority 1 to 8 to
the on state in [Priority 1] to [Priority 8].
Note
The priority options available for selection vary
depending on the number of keys assigned to a
switcher bank.
4
Press [OK].
Checking the key priority settings
When the key priority is set using the transition control
block, the key status and priority are shown on the display.
Key status display
When a key is inserted, [K1] to [K8] are displayed
inverted.
Key priority display
The numbers 1 to 8 (priority 1 to 8) are displayed under the
status indicators for each key.
If the [KEY PRIOR] button is selected in a next transition,
the priority (1 to 8) of keys for after the transition are
displayed inverted on the right of the current priority. The
key priority for after the transition is not displayed if the
values are the same as the current priority setting.
57