Pattern Limit - Sony XVS-G1 User Manual

Notes
• When the background and one or more keys (1 to 8) are
targets of a transition, the transition direction of all
background/keys must be the same as the fader lever
operation direction.
• If as a result of an auto transition, the fader lever position
does not match the background/key signal output state, a
non-sync state occurs and LEDs light/flash at both ends of
the transition indicator.

Pattern Limit

When a wipe or DME wipe is selected as the transition
type, you can specify the transition execution limit.
When the pattern limit function is enabled, the following
transitions occur, depending on the execution limit
settings.
• When the execution limit is set to 50%, the result at the
completion of the transition is the same as if the fader
lever is at the center position with the pattern limit
function disabled.
• When the execution limit is set to the minimum of 0%,
the image is not switched even when the transition is
executed.
• When the execution limit is set to the maximum of
100%, the image changes in the same way as if the
pattern limit function is disabled, but when the transition
is completed, the cross-points on the background A bus
and B bus do not interchange.
The pattern limit is configured using the transition control
block or the menu.
Notes
• When the operation mode of the switcher bank is set to
multi program mode, pattern limits can be set only when
the background transition type is a wipe or DME wipe.
If a key is selected for a next transition, the pattern limit
settings are reflected in the wipe or DME wipe selected
for the background transition type.
• The buttons used for configuring and executing pattern
limits must be assigned to the transition settings section
of the transition control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
To set a pattern limit while checking a transition
preview
Press the [TRANS PVW] button in the transition control
block, turning it on.
You can adjust the pattern limit while checking the
transition status on a monitor set with the preview output.
For details, see "Transition Preview" (page 65).
Setting a pattern limit (transition control
block)
You can set the pattern limit using the transition control
block of the target switcher bank.
Note
Check that the [PTN LIMIT] button is off.
63