Setting An Independent Key Transition Wipe; Setting A Wipe Pattern For An Independent Key Transition; Setting Independent Key Transition Wipe Modifiers - Sony XVS-G1 User Manual

Setting an Independent
Key Transition Wipe
Wipe patterns and modifiers for independent key
transitions are configured using the menu.
This section describes the M/E-1 key 1 menu as an
example.
Setting a Wipe Pattern for an
Independent Key Transition
Selecting a wipe pattern
Note
Only standard wipe patterns can be used in an independent
key transition.
1
Open the Home > M/E-1 > Key1 > Transition > Wipe
menu (11101.52).
2
Press the [Pattern Select] button.
A pattern selection window appears.
3
Set the button for the target wipe pattern to the on state.
4
Press [OK].
Setting Independent Key Transition
Wipe Modifiers
You can set the following modifiers in an independent key
transition.
• Direction
• Soft edge
• Position
• Rotation
• Aspect
• Multiplication
Setting the wipe direction (Direction)
1
Open the Home > M/E-1 > Key1 > Transition > Wipe
menu (11101.52).
2
In the [Direction] group, select a wipe direction.
Normal: Wipe in normal direction.
Normal/Reverse: Alternate directions between
normal and reverse after each transition.
Reverse: Wipe in the opposite direction of the normal
direction.
Softening the wipe pattern edge (Soft
edge)
Softens the edges of a pattern.
1
Open the Home > M/E-1 > Key1 > Transition > Wipe
menu (11101.52).
2
Set the [Soft] button to the on state and set the
following parameter.
No. Parameter
1 Soft
Setting the wipe pattern position (Position)
You can move a wipe pattern to a desired position.
1
Open the Home > M/E-1 > Key1 > Transition > Wipe
menu (11101.52).
2
Set the [Position] button to the on state and set the
following parameters.
No. Parameter
1 Position H
2 Position V
To return a pattern from a moved position to the
center of the screen as a transition progresses
Set the [Auto Center] button to the on state.
Rotating a wipe pattern (Rotation)
1
Open the Home > M/E-1 > Key1 > Transition > Wipe
menu (11101.52).
2
In the [Rotation] group, select a rotation type.
Angle: Wipe with a pattern at a fixed angle.
Speed: Rotate a pattern at a fixed speed.
Magnitude: Rotate a pattern through the specified
angle in a single transition.
When the [Angle] button is selected, set the following
parameter.
108
Adjustment
Edge softness
Adjustment
Horizontal position
• Negative values move left.
• Positive values move right.
Vertical position
• Negative values move down.
• Positive values move up.