Transition Preview; Setting Transition Preview; Executing Transition Preview - Sony XVS-G1 User Manual

Multi format switcher system
Hide thumbs Also See for XVS-G1:
Table of Contents

Advertisement

Independ Trans Rate: Set an independent transition
rate for releasing a pattern limit.
When the [Independ Trans Rate] button is selected, set
the following parameter.
No.
Parameter
Adjustment
1
Transition Rate
Transition rate when the
pattern limit is released

Transition Preview

In transition preview mode, the status during a transition is
output on the preview output of the switcher bank.
You can check the change in the image due to a transition
in advance using a monitor configured for the preview
output.
Notes
• It is not possible to carry out a transition preview in the
following cases.
- Transition in progress
- When bus fixed mode is set
- When the switcher bank operation mode is not
standard mode
• The buttons used for configuring and executing the
transition preview must be assigned to the transition
settings section of the transition control block
beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).

Setting Transition Preview

There are two modes for a transition preview.
Normal:
Set the [TRANS PVW] button operation mode to hold
mode or lock mode.
In hold mode, the transition preview mode is enabled
only while the [TRANS PVW] button is pressed.
In lock mode, pressing the [TRANS PVW] button
switches between transition preview mode and normal
mode each time the button is pressed.
For details about setting lock mode/hold mode, see
"Setting the operation mode of the [TRANS PVW]
button in the transition control block" (page 325).
One-time:
Pressing the [TRANS PVW] button switches to
transition preview mode, and the mode returns to
normal mode when the transition is completed.
For details about setting normal mode/one-time mode, see
"Setting the Transition Preview Mode" (page 311).

Executing Transition Preview

1
Press the [TRANS PVW] button in the transition
control block, turning it on.
The [TRANS PVW] button is lit green, and the
switcher enters transition preview mode.
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents