Cross-Point Button Display; Cross-Point Hold - Sony XVS-G1 User Manual

Hold mode: Mode where the shifted state is selected while
the button is pressed
Lock mode: Mode where every time the button is pressed,
it toggles between the shifted state and unshifted state
You can also disable the shift button function.
For details, see "Setting the Shift Button" (page 302).
Note
The operation mode of the [SHIFT] button is the operation
mode set by the cross-point assign table of the switcher
bank, regardless of the buses assigned to the cross-point
button rows.
[SHIFT ALL] button
You can switch all the cross-point buttons in the 1st row to
4th row to the shifted state using the [SHIFT ALL] button
assigned to the function button section (excluding 1st row
delegation buttons in key/AUX bus delegation mode).
The [SHIFT ALL] button operation can be set to hold
mode or lock mode.
Notes
• The [SHIFT ALL] button is enabled, even if the [SHIFT]
button use is disabled. In this case, the button numbers
are 1 to 24 in the unshifted state, and 25 to 48 in the
shifted state.
• The [SHIFT ALL] button is disabled in the following
cases.
- In [SHIFT] button hold mode
- When dual background bus mode is set
- When dual M/E is set

Cross-Point Button Display

Source name of signals
You can attach a name (source name) to the signal
assigned to a cross-point button, with a maximum of 16
characters.
The specified source name appears on the display of the
cross-point control block. When a signal in the shifted state
of a cross-point button is selected, the source name of the
shifted-state signal is displayed.
Six types of display mode can be set according to the
information to display. The display mode switches each
time the [DISP MODE] button assigned to the function
button section is pressed.
Colors of lit cross-point buttons
In a single cross-point button row, only the last pressed
button is active, and is lit amber or red.
Color of button Button state
when lit
Amber Low tally
Selected signal is not included in the final
output image
Red High tally
Selected signal is included in the final
output image
Cross-point indicators
When lit, these indicate the source color of the video signal
assigned to buttons on the 3rd row of the cross-point
control block.
The color of the cross-point indicators does not change
even if a 3rd row button is lit red or amber.

Cross-Point Hold

Setting cross-point hold enables you to recall an effect
timeline or snapshot while keeping the current cross-point
selection unchanged.
You can set cross-point hold for each cross-point button
row.
To set cross-point hold, press the [XPT HOLD] button for
the 1st row to 4th row assigned to the function button
section, turning it on.
Key bus cross-point hold
For a key bus, the cross-point hold operation mode
specified in the Home > Setup > Switcher > Custom >
Key/Wipe menu (19103.43) is applied.
The following three operation modes can be set.
Key disable: Mode which maintains cross-point selection
state and key setting information
Key disable (including key state): Mode which maintains
cross-point selection state, key setting information,
and the key inserted/removed (on/off) state
Cross-point hold: Mode which maintains cross-point
selection state only
For details, see "Setting the Cross-Point Hold Operation
Mode" (page 313).
Bus override
This function allows you to temporarily set cross-point
hold for specific cross-point buttons only.
It is enabled for background A bus and background B bus
cross-point buttons only.
When you press and hold a cross-point button and recall a
snapshot, the cross-point selection state is maintained for
the pressed button only. The cross-point selection state is
maintained while the button is pressed, even when
executing an effect timeline.
50