Lift Motor Replacement; About; Videos; Specification - Precor Experience 700 Series Service Manual

Lift Motor Replacement

About

This procedure provides instruction to remove and replace the Lift Motor.

Videos

Lubricate the lift motor jackscrew

Specification

System Component
Lift Motor Calibration Distance*
Note: * Calibration distance is specified at incline level 0.

Lift Motor Fuse

The lift motor fuse (2 Amp) is located on the
MC bottom cover to access the fuse. Use a small standard screwdriver to unsnap the clip
fasteners and remove the cover.
1
Lower Printed Circuit Assembly board; also refered to as the Lower PCA or simply as the
lower board. On treadmills, it is the console to base function interface and the motor con-
troller unit (MCU). On self-powered units, it is the lower PCA console to base function inter-
face.
2
Motor controller, motor controller unit, or motor controller module: used on treadmills, con-
tains the LPCA and motor controller functionality.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Specification
1 1/8 in - 1 3/16 in (2.8 cm - 3.0 cm)
1
LPCA board in the MC
6 Replacement Procedures
Lift Motor Replacement
2
module. Remove the
Page 201