Precor Experience 700 Series Service Manual page 229

Remove supports and lower the treadmill
6. Connect the power cord and switch the power ON. Be aware that switching the power
ON will cause the incline platform to move and return to the level "0" position. If you
are using the side access method, see
mill.
WARNING: Keep hands and appendages clear of the lift platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
7. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
8. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as it lowers.
9. Lower the incline to level "0".
Operation Verification
10. Raise the incline to the maximum level. Then clean and apply a thin layer of synthetic
lubricant to the jackscrew.
Lubricate the lift motor jackscrew
11. Verify the treadmill incline operation from minimum to maximum levels. Verify that the
movement is smooth and that there are no unusual noises etc. Go to the Error Log
and make sure that there are no new active incline function related error codes.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
"Side access" on page 82
Lift Platform Replacement
to upright the tread-
Page 219