1. Reinstall the ASL PCA
ASL PCA board into position on the bracket.
2. Reinstall the ASL PCA Bracket
Power Entry Assembly Bracket
3. Reconnect the ASL interface cable RJ11 connector, see
page 117.
4. Reinstall the Power Entry Assembly bracket
fasteners. Make sure that the wire cables are not pinched or damaged during install-
ation.
5. Reinstall the hood cover, see
6. Connect the power cord and switch the ON/OFF circuit breaker ON.
7. Verify the ASL light operation:
a. Verify that the ASL light is Solid Blue. If the ALS light is Pulsing Blue, Pulsing
Yellow, or Solid Yellow, resolve the issue and reset the ASL to Solid Blue.
8. Do the Operation Verification tests (see
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
board onto the ASL PCA Bracket
by pressing the tabs into the mounting slots on the
.
"Hood Cover Replacement" on
"Operation Verification" on
6 Replacement Procedures
ASL PCA Replacement
. Securely snap the
"Wire Diagram" on
and secure using the four #3 Phillips
page 88.
page 24) and
Page 121