Precor Experience 700 Series Service Manual page 108

TIP: Use a short stub #3 Phillips screwdriver to remove the bottom end cap
fastener.
4. Pull the cover away from the frame to release the cover tabs and remove.
5. Repeat the same removal procedure to remove both the left
cap covers.
Installation Instructions
Repeat procedure for both the left
1. Reinstall the end cap cover onto the end of the frame rail and press to lock cover tabs
in place. Secure using the three #3 Phillips screw fasteners. One fastener on the top,
one fastener on the end, and one fastener on the bottom.
2. Repeat the same installation procedure to install both the left
end cap covers.
3. Reinstall the left and right trim landing covers, see
on page 86.
4. Reinstall the hood cover, see
Common Frame Models
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
and right covers.
"Covers and Panels Replacement"
"Hood Cover Replacement" on
6 Replacement Procedures
Covers and Panels Replacement
or right trim end
and right trim
page 88.
Page 98