Drive Roller Replacement" On Page; Take-Up Roller Replacement" On Page - Precor Experience 700 Series Service Manual

1. Switch the power OFF and unplug the power cord.
2. Remove the hood cover, see
left/right Trim Landing covers, see
3. Remove the Take-up Roller, see
4. Remove the Drive Roller, see
5. Remove the left/right rear deck fastener hardware:
a. Remove the left/right #3 Phillips rear deck fasteners (4x) and washers (4x).
These fasteners attach to the left and right rear deck pivot assemblies. The 1/2"
fastener nuts are press fit into the bottom of the deck pivot housing, be aware
that the nuts can fall from the housing as the bolts are being removed. If this
happens, reinsert the nut into the pivot housing. Retain part(s) and/or fastener
(s) for installation.
b. If the deck is being flipped or replaced, use a plastic putty knife sharp edge to
pry up and remove the pine tree clips (2x). Alternatively you can pop the pine
tree clips from the back side after the deck is removed. Retain part(s) and/or
fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Running Belt and Deck Replacement Procedure
"Covers and Panels Replacement" on
"Covers and Panels Replacement" on
"Take-up Roller Replacement" on
"Drive Roller Replacement" on
6 Replacement Procedures
page 86, and
page 86.
page 178.
page 168.
Page 195