Precor Experience 700 Series Service Manual page 153

Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
3. Remove the left and right trim landing covers, see
ment" on page 91.
4. Use a 5/16" hex key socket and ratchet to relax the running belt tension by alternately
loosening the left and right belt tension adjustment bolts in 1/4 turn increments until
the tension is fully removed. Use this method to evenly remove the left and right belt
tension. Do not use power tools which can make it difficult to control the left/right 1/4
turn incremental bolt loosening requirement. Uneven belt tension removal can cause
damage to the running belt or tension adjustment hardware.
CAUTION: Only use hand tools to adjust tension. Power tools can easily over
and/or under tension causing damage to the belt and/or tension hardware mech-
anism.
5. Walk the Drive Belt off the Drive Roller pulley and then the Drive Motor pulley. Tem-
porarily place the Drive Belt on the inside of the Drive Roller pulley.
TIP: Use (turn) the Drive Motor flywheel to make it easier to turn the motor pul-
ley and help walk the belt onto or off the Drive Motor and Drive Roller pulleys.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1
unplug the power cord.
"Covers and Panels Replacement" on
6 Replacement Procedures
Drive Belt Replacement
page 86.
"Trim Landing Covers Replace-
Page 143