Precor Experience 700 Series Service Manual page 201

7. Carefully lift the deck and belt out of the treadmill frame.
8. Remove the running belt from the deck and discard. A new deck surface must be
used with each new belt replacement.
a. Both sides of the running deck are designed to be used. Flip the deck over and
verify the condition of the flipped side of the deck. If the condition is new you
can reuse the removed deck. If both sides of the removed deck are used, dis-
card the deck, and replace with a new deck.
Installation Instructions
CAUTION: A new deck surface must be used with each new running belt replace-
ment.
CAUTION: Make sure the correct running belt brand and deck combination are
installed together:
The Ammeraal Beltech running belt is a wax infused self-lubricating belt
l
used with a non-waxed deck.
The Forbo brand running belt is not self-lubricating and must be used with a
l
pre-waxed deck.
1. Reinstall the deck into the running belt. Make sure the running belt direction is correct.
There are two direction indicators, the belt logo and the Run direction arrow printed
on the inside of the belt right edge. Make sure that the belt direction logo and Run
arrow are installed as shown.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Running Belt and Deck Replacement Procedure
Page 191