Precor Experience 700 Series Service Manual page 53

INFORMATION DISPLAY
METRICS BOARD SW
SER NUMBER
USAGE LOG
"Error Log & CPA Event Log"
on page 230
TREADMILL
(1)
MAINTENANCE
(1) Only used on products with the ASL feature. Not included on the EFX600 series, the
TRM600 series, or the TRM800-10 (TRM10/GEN06) series products.
(2) TRM600 series treadmills only.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
DESCRIPTION
The console Metrics board software version information
Shows the model and serial number of the machine. The
base serial number can be set using the WinCSAFE
computer software. The factory default is NONE.
Shows workout usage information for each individual
workout including the number of times and the total accu-
mulated time the workout was used.
Table of stored error event codes.
TIP: You can quickly access the Error log by holding
down the PAUSE key. Will show the STUCK KEY mes-
sage when there are no logged error codes.
Used to monitor and reset the 1000 mile belt cleaning
maintenance reminder. Mileage counter starts at 1000
miles and decreases to 0 miles which triggers a blue
pulsing ASL light indicating it's time for belt cleaning
maintenance.
The maintenance counter and ASL light is reset as fol-
lows:
P10/P30 console
1. Select Treadmill Maintenance.
2. Press and hold QUICKSTART until 1000 Miles is dis-
played. The ASL light is also reset.
3. Exit the menu by pressing BACK or
PAUSE/RESET.
P62, P80, and P82 consoles:
The maintenance reminder counter reset "Maintenance
Due" parameter is located in the Maintenance menu:
1. Access the service diagnostics (5,1,7,6,5,7,6,1).
2. Select Maintenance page.
3. Select Next Maintenance Due page > Reset.
Note: On P62, P80, and P82 the belt cleaning reminder
ASL Blue flashing state can be switched ON or OFF,
select Maintenance Reminder > ON/OFF.
4 Standard Service Menus
LED Console Standard Service Menus
Page 43