Lift Motor Replacement
About
This procedure provides instruction to remove and replace the Lift Motor.
Specification
System Component
Lift Motor Calibration Distance*
Note: * Calibration distance is specified at incline level 0.
Procedure
Removal Instructions
Review entire procedure before starting.
1. Remove the hood cover, see
2. You can access the lift motor jackscrew in one of two methods: 1) by raising the tread-
mill provideding access from the front of the treadmill or 2) by laying the treadmill on its
side. This procedure uses the front access method. If you do not have supports avail-
able, then use the alternative side access method, see
Experience Series 700 Line Treadmills
1 1/8 in - 1 3/16 in (2.8 cm - 3.0 cm)
"Hood Cover Replacement" on
5 Replacement Procedures
Lift Motor Replacement
Specification
page 56.
"Side lift platform assembly
122