Table of Contents
Advertisement
3. Remove the two screws, and then remove the fan holder.
4. Remove the DC fan assembly.
Note
Install the DC fan assembly carefully paying attention to the label side and the harness position.
5. Remove the fan cushion from the DC fan.
Fan cushion
DC fan
Note
At the time of the installation, attach the fan cushion from the start position as shown in the figure.
6. Install the removed parts by reversing the steps of removal.
Boss
Label
DC fan assembly
Start position
Harness (RE-FAN)
Boss
Harness
Fan holder
Hole
Hole
Label
Harness
Fan cushion
P1.7 x 3
78
Advertisement
Table of Contents
