2. Remove the REC button and the hold switch.
Hold switch
REC button
Note
•
At the time of installation, attach the REC button with the orientation shown in the figure.
•
At the time of installation, push the hold switch in the direction of the arrow.
3. Release the coaxial cable from the hook, and then disconnect the coaxial cable from the connector
(J7391) on the WF-1008 board.
4. Remove the screw, and then remove the WF-1008 board.
Note
•
At the time of installation, arrange the coaxial cable as shown in the figure.
•
At the time of installation, be careful not to damage the coaxial cable with the REC plate.
P1.7 x 3
Hole
Boss
J7391
Arrangement of coaxial cable
REC button
WF-1008 board
Coaxial cable
Hook
Hooks
REC plate
Hole
Hold switch
Coaxial cable
68