Table of Contents
Advertisement
2-3-2. HP-1015 Board
Preparation
1. Remove the top cabinet and the bottom cover. (Refer to "2-2. Top Cabinet, Bottom Cover".)
2. Remove the inside panel. (Refer to "2-3. Inside Panel".)
Procedure
1. Disconnect the flexible flat cable from the connector (CN0301) on the KY-1031 board.
2. Open the HP terminal cover, and then remove the nut.
3. Remove the HP-1015 board, and then disconnect the flexible flat cable from the connector (CN0101)
on the HP-1015 board.
Reinforcing plate side:
How to fold the flexible flat cable
Half
Half half
Mountain fold
Valley fold
Note
•
Cut the pins on a new HP-1015 board to a length of 1.2 mm or less.
•
When you use a new flexible flat cable, fold it as shown in the figure.
4. Install the removed parts by reversing the steps of removal.
HP-1015 board
Flexible flat cable
KY-1031 board
Pins of the connector
CN0101
HP terminal cover
CN0301
Nut
47
Advertisement
Table of Contents
