8. Disconnect the flexible boards from the connectors (CN2002, CN2005) on the PD-1066 board.
9. Disconnect the flexible flat cable from the connector (CN1000) on the PSW-1001 board.
10. Remove the four screws and lift the PD-1066 board.
11. Disconnect the connection cable from the connector (CN2001) on the PD-1066 board.
12. Disconnect the flexible flat cable from the connector (CN2003) on the PD-1066 board.
TP1.7 x 5
(a)
PD-1066 board
Bosses
Bosses
Note
•
When installing the PD-1066 board, align the groove of the panel mirror lever with the switch.
•
When installing the PD-1066 board, tighten the screws in the following sequence: (a), (b), (c), (d).
13. Install the removed parts by reversing the steps of removal.
Connection cable
CN2001
CN2002
CN2005
(b)
Flexible boards
Groove of the panel mirror lever
(c)
Flexible flat cable
(d)
CN2003
Switch
PSW-1001 board
CN1000
Reinforcing plate side:
125