Table of Contents
Advertisement
5. Disconnect the flexible flat cable from the connector (CN2005) on the UIF-1001 board.
6. Remove the two screws, and then remove the UIF-1001 board.
UIF-1001 board
CN2005
P2 x 4
Note
At the time of installation, arrange the flexible flat cable as shown in the figure.
7. Disconnect the flexible flat cable from the connector (CN001) on the UC-1001 board.
8. Remove the two screws, and then remove the UC-1001 board.
Hole
UC-1001 board
Groove CN001
9. Install the removed parts by reversing the steps of removal.
Arrangement of flexible flat cable
Flexible flat cable
Bosses
Flexible flat cable
Flexible flat cable
134
Advertisement
Table of Contents
