4. Peel off the tape AS.
Note
The tape AS is not reusable.
5. Remove the supplied nut of the FU-1001 board, and then remove the FD plate.
Tape AS
FU-1001 board
Note
•
Cut the pins on a new FU-1001 board to a length of 1.2 mm or less.
•
Attach the tape AS at the position as shown in the figure.
6. Install the removed parts by reversing the steps of removal.
Pins of the connector
FD plate
Supplied nut
Tape AS sticking standard
Sticking standard
Tape AS
Sticking standard
56