2. Remove the screw, and then remove the WB-1002 board.
PUSH AUTO button plate
Boss
Tip
At the time of installation, observe the following instructions.
1. Insert the convex portion of the WB-1002 board into the hole of the PUSH AUTO button plate.
2. Align the hole of the WB-1002 board with the boss of the PUSH AUTO button plate.
3. Tighten the screw.
3. Install the removed parts by reversing the steps of removal.
Hole
Convex portion
Hole
WB-1002 board
P1.7 x 3
61