Table of Contents
Advertisement
3. Open the SDI terminal cover.
4. Remove the supplied nut, and then remove the SDI-1004 board.
5. Remove the SDI shield case from the SDI-1004 board.
Loctite 243
Supplied nut
SDI terminal cover
Note
•
After installing the SDI shield case, make sure that the SDI shield case is inserted all the way into
the all clips.
•
Before installing the supplied nut, apply loctite 243.
6. Install the removed parts by reversing the steps of removal.
SDI-1004 board
Clips
SDI-1004 board
SDI shield case
101
Advertisement
Table of Contents
