Procedure
1. Open the elongated part of the harness guide VC, disconnect the fine-wire coaxial cable from the
connector (CN0200) on the CK-1027 board and the connector (CN3502) on the VC-1046 board.
2. Release the fine-wire coaxial cable from the two notches of the harness guide VC.
Arrangement of fine-wire
coaxial cable
Fine-wire coaxial cable
Insert the elongated part of the
harness guide VC into the notch.
Note
At the time of installation, arrange the fine-wire coaxial cable as shown in the figure.
CK-1027 board
CN0200
VC-1046 board
Notches
Harness guide VC
CN3502
Pass the binding section of the
fine-wire coaxial cable through
the notch.
Harness guide VC
Pass the binding section of the
fine-wire coaxial cable through
the notch.
Fine-wire coaxial cable
73