2-16-3. AXM-1002 Board
Preparation
1. Remove the HC-1002 board. (Refer to "2-16-1. HC-1002 Board".)
2. Remove the handle top cover assembly. (Refer to "2-16-2. Handle Top Cover Assembly".)
Procedure
1. Remove the four screws, and then remove the AXM-1002 board assembly.
Positions of the XLR slide switches
AXM-1002 board assembly
BTP2.6 x 10
Note
At the time of installation, push the slide switches in the direction of the arrows.
2. Remove the two XLR slide switches and the XLR slide switch cover.
3. Disconnect the flexible flat cable from the connector (CN3000) on the AXM-1002 board.
CN3000
AXM-1002 board assembly
Flexible flat cable
XLR slide switches
XLR slide switch cover
4. Install the removed parts by reversing the steps of removal.
113