Power Failure - Avaya 6424D+M User Manual

To cancel SSI light test (the turnkey should be turned fully counterclockwise):
1.
Lift the handset.
Listen for dial tone.
2.
Dial Light Test Cancel code.
Listen for confirmation tone. All RLT status lights on SSI go off.
3.
Hang up.

Power Failure

All calls in progress, calls on hold, and/or established calls are lost when a power failure
occurs and battery backup is not provided.
As part of the power-on sequence, the system always returns to operation in the Unattended
Console Service mode. The UNA light flashes. If a continuous tone is heard when power is
restored, operate the TEST switch located at the front of the console to remove the tone.
To place the system in normal operation:
1. Press .
[UNA]
2. Check features (such as Attendant Control of Trunk Group Access, Attendant-
Controlled Voice Terminal Restrictions and Trunk-to-Voice Terminal Assignments set
up by the attendant to answer calls) to see if currently activated features and/or
services are still in operation.
To turn off the reload warning light after a system initialization or memory reload:
This operation can also be done from an ACD split supervisor voice terminal
Note:
(System 85 R2V2, R2V3, R2V4, and DEFINITY Generic 2).
Press an idle loop button.
1.
ATND light goes on. PA light goes off.
2 .
Press .
[START]
Listen for dial tone.
3 .
Dial the access code to turn off the reload warning light.
Listen for confirmation tone (three short beeps). Warning light goes off.
Press
4 .
[RELEASE]
.
CHAPTER 4. OPERATING FEATURES
4-87