Avaya 6424D+M User Manual page 80

CHAPTER 4. OPERATING FEATURES
If you use direct trunk group selection to select radio paging trunks, do Step 3. If you
2.
do not use direct trunk group selection, go to Step 4.
3. Press direct trunk group select button.
Listen for dial tone. ANS light goes on.
4. Press ,
and dial Radio Paging access code.
[START]
Listen for dial tone. ANS light goes on.
Dial individual Page Number.
5.
Listen for ringback tone until paging signal has been transmitted. If voice paging is
available, go to Step 6; if tone paging only is available, go to Step 10.
Announce paging message. If a caller is waiting to talk to the paged party, go to
6.
Step 9. If a caller is not waiting, do Steps 7 and 8.
7. If an answer is expected, stay on the line until the called party is connected.
8. At the end of conversation, press
ANS and ATND lights go off. PA light goes on.
9. Press .
[HOLD]
HOLD and PA lights go on. Display and ATND lights go off. Caller is connected to
the paged party.
10. Press
[RELEASE]
Display and ATND lights go off.
Remote Access
Allows users on a public network to access the services of your system by dialing a single
security code (barrier code) or an individual authorization code. You may have to change the
barrier code (same code for all remote access users) from time to time for security reasons.
To change the barrier code:
1. Press an idle loop button.
PA light goes off. ATND light goes on.
4-58
[RELEASE]
.
PA
light goes on.
.