Avaya 6424D+M User Manual page 71

7. Dial the outside number.
Listen for ringback tone until called party answers. If you used AAR/ARS to connect
a trunk, ANS light goes on.
Announce the conference, and do a or b.
8.
a. To add the conferee, press
ANS and SPLIT lights go off.
If unable to add the conferee, press
b.
Called party is released. You have reestablished a connection to the
conference. Advise the conferees.
9. To add voice terminal users as requested, press the appropriate group select button
and the DXS button for the desired extension number.
To release from the conference, press
10.
sure one conferee is an extension number user and is local to the attendant.
Otherwise, outside parties will be disconnected.
11. When a conference recall occurs after you have released, press loop button
associated with the flashing ATND light.
ATND light goes on. Audible ring stops. Display shows
12. Give information or assistance as necessary.
To place a conference on hold:
1. Press .
[HOLD]
ATND and conference CONT lights go off. PA and HOLD lights go on.
2. To reenter a conference on hold, press loop button associated
conference.
ATND and conference CONT lights go on. PA and HOLD lights go off.
3. If you are recalled by the conference that is on hold, the HOLD light flashes. You
hear timed-reminder tone. Press the loop button below the flashing HOLD light.
Ringing tone stops. ATND and conference CONT lights go on. PA and HOLD lights
go off.
CHAPTER 4. OPERATING FEATURES
.
[CONF]
.
[CANCL]
. However, before releasing, make
[RELEASE]
.
CONF
with the held
4-49