Avaya 6424D+M User Manual page 65

4.
Dial CDRR account number access code and Account Charge Number.
Listen for dial tone.
5. Dial Code Calling access code.
Listen for tone:
Dial tone— ANS light goes on. Do Steps 6 and 7.
Busy tone—code calling circuit is busy. Go to Step 8.
6. Dial Called Party Code.
Listen for confirmation tone. Then listen for the Called Party Code to be repeated
three times. Then listen for ringback tone.
7. Press .
[HOLD]
Display and ATND lights go off. HOLD and PA lights go on. Caller is connected to
the paged party.
8. Remove the caller from hold, and report the busy condition.
9. Press
[RELEASE]
Display and ATND lights go off. PA light goes on.
Conference—Attendant 6-Party
Allows you to arrange a conference call for up to six conferees including voice terminal users
inside the system and individuals outside the system.
To stay within FCC requirements, the sum of the number of Central Office (CO) and Direct
Inward Dialing (DID) trunks connected in an Attendant Conference should not be more than
two. The number of tie trunks that may be added in an Attendant Conference is not
restricted.
Only one CONF button per console is provided, but several conference circuits may be
provided, depending on the size of your system.
To start a new conference, you must release from the conference on which you are active, or
you can place the active conference on hold. The BUSY light above the CONF button goes
on when all conference circuits are busy.
The CONT light above the CONF button goes on each time you press the CONF button. You
may add conferees even though the CONF BUSY light is on. (Specific conference may not
yet have six conferees active.) When you add a sixth conferee to a conference, the WARN
light above the CONF button goes on.
.
CHAPTER 4. OPERATING FEATURES
4-43