Canon imageRUNNER ADVANCE C5000 Series Technical Workbook page 99

6) Remove the torque limiter [1], and install the black marked torque limiter (FE3-4566-000). The photo
shows the torque limiter that is fitted in the product at the factory and has the red mark.
7) Reverse the steps from step 5) to install the parts.
8) Place the originals on the document tray and scan or copy to make sure that the symptom is improved. If
the symptom is improved, the work is completed. If an original feed fault or multi feed occurs, proceed to the
following step.
a) If original feed fault occurs:
The torque limiter prepared this time (FE3-4556-000) has an original multi feed prevention feature (for
applying force to return the original(s)) which is too strong. Thus, prepare the red marked torque limiter
(FC8-5907-000) and the arm sensing sheet set (FM4-9078-000), and proceed to step 9). The blue marked
torque limiter (FC7-2494-000) having low separation performance is fitted on the feeder with a serial number
earlier than the following serial numbers. Be sure to prepare the red marked torque limiter.
Model
Color Image Reader-A1(INCH/AB)
Duplex Color Image Reader-A1(INCH/A)
Duplex Color Image Reader-A1(A)
Duplex Color Image Reader-A1(INCH/AB)
b) If multi feed occurs:
With the replaced torque limiter (FE3-4556-000) installed, prepare the arm sensing sheet set
(FM4-9078-000) and proceed to step 9).
9) In Settings/Registration > Function Settings > Common > Scan Settings > Timing to Raise Feeder Tray,
select "When Panel Is Touched" and press "OK" button to close the setting screen.
Serial #
GDA00065
GDD02903
GDF01723
GDJ00062
97