Canon imageRUNNER ADVANCE C5000 Series Technical Workbook page 238

[Caution] When installing the rail cover (rear) [1], fit teeth [A] of the rail cover (rear)
[1] and teeth [B] of the gear [2] together and then push in the rail cover (rear) until it
stops.
30) Remove the 4 connectors [1] and 8 wire saddles [2] to detach the harness.
31) Put the high voltage PCB [1] back to the original position and put the harness [2] inside
the host machine. Be careful not to pinch the harness when closing the controller box [3].
Remove the 2 screws [4] of the hopper unit (Y)/ (M)/ (C).
YMC
20