22) Close the Process Unit Inner Cover. Install the Front Inner Handle Left Cover [1] and the Front Inner
Handle Right Cover [2] in the direction of the arrows, and tighten 1 screw [3] for each cover.
23) Install the flywheel [1] with 3 screws [2].
24) Press the Drum Drive Unit (Bk) [1] against the rear plate. While rotating the flywheel to align it with the
screw holes, fully tighten 3 screws [2].
25) Remove the Front Inner Handle Left Cover and the Front Inner Handle Right Cover. Open the Process
Unit Inner Cover, and remove the Drum Cap installed at step 21).
pg. 138