Canon imageRUNNER ADVANCE C5000 Series Technical Workbook page 170

IF A MACHINE HAS THE NEWER TYPE HOPPER INSTALLED, ENSURE THAT
THE NEWER TYPE STEPPED SCREW FS2-9012-000 IS INSTALLED
IN "POSITION 1", AS INDICATED IN PAGE 5 AS WELL AS ON
FS5-9216-020 MUST BE USED WITH OLDER STYLE HOPPER IN POSITION 1
FS2-9012-000 MUST BE USED WITH NEWER STYLE HOPPER IN POSITION 1
The shape of the positioning hole on the plate of the Black Hopper Assembly (FM3-4715) has been modified.
The Black Hopper "Positioning Hole" on the left side of the assembly was changed to a horizontally
elongated hole to prevent abnormal stress from being applied to the Black Hopper. The Black Hopper
alignment is enhanced by using one Stepped Screw only on the left side of the assembly, as shown above.
Service Work:
If E025-0402 occurs, or if replacing the Black Hopper Assembly (FM3-4715) due to some other reason,
please, perform the following operation. Servicing work for both, older style Hopper and newer style Hopper
is described below.
(Step 1)
Actions Common to Both Newer and Older Style Black Hoppers:
A. Check to see that the tie-wraps for cable routing are not pinching the wires in the black hopper
assembly. Check if the tie-wrap around the yellow cable has been tucked into the gap between the
Toner Supply Pipe and plate of Developing Drive. If the wire does not move, it may be pinched.
STEP 2 ON PAGE 7.
THESE TWO SCREWS ARE NOT INTERCHANGEABLE.
e-Support Filename:
Area below the Hopper
TP10 123b.pdf
06-19-13
Date:
Page 8 of 15