Table of Contents
Advertisement
displaying a transition rate enables you to enter a transition
rate using the numeric keypad control block.
You can change the target that is displayed on the [TRANS
RATE1] to [TRANS RATE3] buttons in the Setup menu
(see page 389).
TC button
Numeric keypad control block
1
Press the [TRANS RATE1] to [TRANS RATE3]
buttons in the utility/shotbox control block.
This switches the memory recall buttons to transition
rate display mode.
2
Press a memory recall button displaying the transition
rate to set, turning it on.
The region name and transition rate appears in the
numeric keypad control block display.
3
Enter the transition rate using the numeric keypad in
the numeric keypad control block.
You can switch the input mode using the [TC] button.
In frame input mode, enter three digits. In timecode
input mode, enter four digits.
To clear the entered value, press the [CLR] button.
4
Press the [ENTER] button.
The input is applied, and the specified value is
reflected in the memory recall button in the utility/
shotbox control block.
The specified value is also displayed in the transition
rate display section of the transition control block.
CLR button
Display
ENTER button
Numeric keypad buttons
To enter a difference value
To set the transition rate by specifying a difference value
from the current value, press the [+/−] button, enter the
difference value, and press the [TRIM] button. Each time
you press the [+/−] button, it toggles between plus (+) and
minus (–).
Setting the transition rate (menu)
This section describes setting the transition rate on the M/
E-1 bank as an example.
1
Open the M/E-1 >Misc >Transition menu (1171).
2
Select the transition type in the <Transition Type>
group.
3
Set the transition rate.
No.
Parameter Adjustment
1
Transition
Rate
To display the transition rates in list view and
change the settings
You can display the transition rate, independent key
transition rate, and fade-to-black transition rate for each
bank, and change the settings (see page 174).
Pattern Limit
When a wipe or DME wipe is selected as the transition
pattern, you can specify the transition execution limits for
each bank independently.
When the pattern limit function is enabled, the following
effects occur, depending on the execution limit settings.
• When the limit value is set to 50%, the effect at the end
of the transition is the same as when the fader lever is at
the center position with the pattern limit function
disabled; namely, the video is not completely switched.
• When the limit value is set to the minimum of 0%, the
video is not switched even when the transition is
executed.
• When the limit value is set to the maximum of 100%, the
image changes in the same way as when the pattern limit
function is off, but when the transition is completed, the
cross-point selections on the background A and B buses
do not interchange.
There are two ways of setting a pattern limit: either by
operating the fader lever to save the fader position, or by
using the Wipe >Edge/Direction menu or DME Wipe
>Edge/Direction menu for the M/E or PGM/PST bank.
86
Transition rate
Advertisement
Table of Contents
